This is an obsolete product, no longer available for purchase.
The DSE9240 is a 3.5 Amp battery charger suitable for 24 Volt lead-acid batteries. The charger is designed to be permanently connected to automotive batteries, keeping them charged to their maximum capacity. The charger can also be used to supply a standing load that is attached to a battery.
To improve reliability the chargers do not include anymoving parts.
The technology inside the chargers has been designed to avoid overcharging and overloading. The chargers will also continue to operate during cranking and running and have the ability to accept multiple AC voltage connections.
The charger has been designed to supply current to a battery until the battery terminal voltage is equal to the set float voltage. After this it will change to a trickle charge current. When the battery voltage falls, due to a load being applied and the battery being discharged, the charger will supply current to restore the voltage of the battery to the float voltage.
• Compact design
• Can remain operational during engine cranking and running
• Suitable for connection to a wide range of AC voltages between 100V and 240V, 50Hz or 60Hz
• No moving parts
• Switch mode design
• Overload & short circuit protection
• LED charging indicator
• Convection cooling
• Minimum 80% efficiency throughout full operating range
12V DC or 24V DC Nominal
100V - 240V 50Hz/60Hz 2.5A Max
7.3A @ 13.7V DC
3.5A @ 27.4V DC
Short Circuit, Over Voltage,
Over-current, Reverse Polarity
Charger On LED
200.000 MTBF per MIL-HDBK-217F
206mm x 136mm x 57mm
8.1” x 5.4” x 2.2”
1.16 kg (2.55 lb)
OPERATING TEMPERATURE RANGE
0°C to +50°C, 5% - 95% RH non-condensing (-45°C to +85°C Storage)
2g 10Hz - 500Hz 3 axes