Deep Sea Electronics

DSEDse-power

DSE5105

5 Amp Battery Charger

Features

The model 5105 is a 5 Amp battery charger designed for permanent connection to automotive batteries, maintaining them in a fully charged condition without overcharging. The chargers are also capable of rapidly recharging the batteries at a current up to the full rated output. The charger may also be used to supply a standing load attached to the battery. The charger output may be factory set to account for the
standing load.

The charger is designed for reliability, ease of installation and accessibility during routine servicing.
It features radio frequency suppression and its smooth output linear mode design has a low ripple
voltage making the charger suitable for use with electronic equipment.

The charger has both Overload and Short Circuit protection features, achieved by limiting the current to a
safe value during these conditions. It will automatically recover after the condition is removed.  If a short circuit or a severe overload is applied such that the voltage falls below four volts for longer than 10
seconds, then the Charge Fail Alarm relay will energise and the charge fail contact will close.

If the charger is inadvertently reverse connected to the battery then the fuse-link on the circuit board will
rupture. This should be replaced with a 10A quick blow type.

The electronic control circuit ensures that the charger can remain operating during engine cranking and running, operating in parallel with the charge alternator where necessary.

The charger features a boost charge facility to enable rapid recharging of discharged batteries or to allow
periodic equalisation of battery cells. When the ‘boost mode select’ terminals are connected together the
charger output will rise by 0.35V per cell.

Image of DSE5105

Specification

DC OUTPUT
12 V DC or 24V DC Nominal
(specified on ordering)

AC INPUT
220 - 250 V AC 50/60Hz
(Specified on ordering)

OUTPUT CURRENT
5 Amps electronically limited
(specified on ordering).
 


INDICATIONS‘Charger On’ LED

PROTECTIONS
Short Circuit, Over Voltage,
Over-current, Reverse Polarity,
Reverse Power

BOOST MODE
+0.35V per Cell above Float
voltage.
 



OPERATIONThe charger will supply current
to the battery until the battery
terminal voltage is equal to the
set float voltage, at which point
only a trickle charge current is
present. When the battery
voltage falls due to a load being
applied and the battery being
discharged, the charger will
once again supply current to
restore the voltage of the battery
to the float voltage.

Downloads

Environmental Testing Standards

TEMPERATURE

BS EN 60068-2-1
Ab/Ae Cold Test -10 °C
BS EN 60068-2-2
Bb/Be Dry Heat +60 °C

Associated products