[ Skip Navigation ]

DSE Products

  • DSEUltra
  • DSE6110
  • Auto Start Control Module

  • The DSE6110 is an Auto Start Control Module for single gen-set applications. The module has been designed to work with electronic and non electronic engines providing advanced engine monitoring and protection features.    The module includes a backlit LCD display which clearly shows the status of the engine at all times. It monitors, speed, frequency, voltage, current, oil pressure, coolant temperature and fuel level. The module has also been designed to display the warning and shutdown status of the engine.   The module includes six digital inputs, three analogue inputs and six outputs. Two of the outputs are configurable on the magnetic pick-up version and all six are configurable on the Canbus version. The module can either be programmed using the front panel or by using the DSE Configuration Suite PC software.

       

  • Downloads
  • T (Translations)

Further Information

Main Features

NEW FEATURES

  • Start on low battery
  • Clock
  • Scheduler

STANDARD FEATURES

  • CAN and magnetic pick-up versions
  • PC and front panel configurable
  • 6 digital inputs/3 analogue inputs
  • 6 outputs (2 configurable on Magnetic Pick-Up, 6 configurable on Canbus version)
  • Event log (10)
  • Configurable timers
  • Automatic shutdown or warning when fault conditions are detected
  • Remote start on or off load
  • Engine pre-heat
  • Advanced metering capability   
  • Engine hours counter
  • Red LED indicators for warning or shutdown•
  • Back-lit LCD Display     
  • Protected Solid State Outputs (PSS)
Benefits

 User-friendly set-up and button layout

  • Multiple engine parameters are monitored simultaneously
  • Module can be configured to suit individual applications
  • Wide range of engines can be specified
  • Uses the DSE Configuration Suite PC Software for simplified programming
  • IP65/NEMA 12 rating offers advanced resistance to water ingress (Gasket required)
  • License free PC software

  •  Hours counter provides accurate information for monitoring and maintenance periods

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

     

    		•
    Operation

    Manual Mode

    • The engine is started using the Start button on the front of the module
    • Once pressed the module instructs the engine to initiate its pre-heat sequence and then start the engine
    • To stop the engine the Stop button on the front of the module should be pressed

    Auto Mode

    • The Auto button needs to be pressed to put the unit into auto mode
    • The module start sequence is initiated by the activation of the remote start input
    • The pre-heat sequence is then initiated and the engine is started
    • To stop the engine the remote start signal needs to be removed or the Stop button on the module needs to be pressed.
    Alternative /
    Associated Products    		 DSE6120 - Auto Mains (Utility) Failure Control Module