[ Skip Navigation ]

DSE Products

  • DSEExtra
  • DSE5103 (OBSOLETE)
  • 3 Amp 12/24 Volt Battery Charger (OBSOLETE)

  • The DSE5103 is a 3 Amp 12/24 Volt Battery Charger.  It is designed to be permanently connected to automotive batteries, maintaining them in a fully charged condition without overcharging.  The charger is also capable of rapidly recharging batteries at a current up to the full rated output.  The charger may also be used to supply a standing load attached to the battery.  The charger output may be factory set to account for the standing load.

    The charger is designed for reliability, ease of installation and accessibility during routine servicing.  It features radio frequency suppression and its smooth output linear mode design has a low voltage making the charger suitable for use with electronic equipment.

  • Downloads
  • T (Translations)

Further Information

Main Features

Overload and Short Circuit Protection: These are achieved by limiting the current to a safe value during these conditions.  It will automatically recover after the conditions are removed. 

Charge Fail Warning: If a short circuit or a severe overload is applied, such that the voltage falls below four volts for longer than ten seconds, then the Charge Fail Alarm relay will energise and the charge fail contact will close.

The charger can remain operational during engine cranking and running, operating in parallel with the charge alternator where necessary.

The charger features a boost charge facility to enable rapid recharging of discharged batteries or to allow periodic equalisation of battery cells.  When the 'Boost Mode Select' terminals are connected together the charger output will rise by 0.35V per cell.
Important Notes

Also available in 5 Amp Version - DSE5105

THIS PRODUCT IS NOW OBSOLETE
Alternative /
Associated Products		 DSE9120 (Obsolete) - 12 Volt Switch Mode Battery Charger
DSE9240 (Obsolete) - 24 Volt Switch Mode Battery Charger
DSE5105 (OBSOLETE) - 5 Amp 12/24 Volt Battery Charger (Obsolete)